NOTE
Whenever possible, the reader should be operated out of the
carrying case. Should it be necessary to operate the
reader in the carrying case, connect the appropriate power
cable as indicated in Step 14; then reassemble the battery
and connector case and the unused power cable, if provided,
in the battery and connector case prior to reassembly.
Ensure that the cables are routed between foam blocks on
the cover plate assembly. When using the battery cable for
reader operations in the carrying case, the cable must be
routed from PLA plug through the battery and connector case
to the lithium battery. When using the vehicle cable for
reader operation in the carrying case, the cable must be
routed from plug PLA through the battery and connector
case, then through the hole in the cover plate assembly,
and finally through the hole in the rear of the carrying
case. Install the reader and the battery and connector
case assembly as a unit in the carrying case.
(Figure 5-26).
then to the lithium battery or vehicle power supply
(24), DC nominal, (Figure 5-26).
Step 15. Turn DISPLAY control (18) on the front panel fully
clockwise. Turn LAMP control (19) fully
counterclockwise, (Figure 5-26).
Step 16. Set selector switch (20), (Figure 5-26), on front
panel to supply position.
Step 17. Press and release DEPRESS FOR READING switch (21) on
front panel and ensure reading on the digital panel
meter (DPM)(22), (Figure 5-26), is between 200-300
and the digital panel meter (DPM) display remains lit
for approximately 2 to 4 seconds.
Step 18. Press and release DEPRESS FOR READING switch (21)
again and adjust DISPLAY control (18) until the
digital panel meter (DPM) display brightness is
satisfactory, (Figure 5-26).
Step 19. Loosen screw (23) 1/2 turn and raise block (24),
(Figure 5-26).
IS0345
5-28
Previous Page
