d. Lift the detector paper strip off cutting edge, then pull both
strips out another inch.
e. Tear through the remaining half of the detector paper strip.
f. Tear off the OD Paper Strip, but leave enough sticking out to
be ready for your next use.
9.
Put M9 Detector Paper on MOPP Gear.
An individual wears the detector paper around the right arm, the left
wrist, and either ankle. The adhesive side of the M9 Paper attaches
to the nonadhesive side.
NOTE
Do not wear the paper band so tightly that it will tear
with movement. However, do not wear it so loosely that it
may slip down. Detector paper will not stick to dirty,
oily, or greasy surfaces. The M9 Paper is also attached to
a vehicle, a piece of equipment, or supplies at locations
where it can be seen by the driver, commander, or ground
sentry. The detector paper must be wrapped around parts of
the equipment where it will not be stepped on.
a. Place M9 Detector Paper on opposite sides of the body.
b. If you are right handed, place a strip of M9 Detector Paper
around your right upper arm, left wrist, and around your right ankle
(Figure 4-3).
c. If you are left handed, place the M9 Detector Paper around
your left upper arm, right wrist, and around your left ankle.
Figure 4-3.
Position of M9 Detector Paper on MOPP Gear
IS0345
4-6
Previous Page
