Figure 4-18.
Test Spots Down
(4) Remove pull tab and rub Lewisite Rubbing Tab.
(Refer
back to Figure 4-15.)
(5) Hold sampler with test spots or arrow pointing up, and
using Heater Pads, crush the two outer ampoules marked No. 3. (Refer
back to Figure 4-11).
(6)
Turn sampler upside down and wet test spots.
(7) Hold sampler with test spots or arrow pointing down, put
your thumb on protective strip over middle test spot (Figure 4-19).
(8)
Swing heater away from test spot (Figure 4-19).
Figure 4-19.
Swing Heater from Test Spot
4-23
IS0345
Previous Page
