Figure 5-12.
Captive Screws on AN/VDR-2 RADIAC Set
CAUTION
When batteries are removed from the RADIAC Set, memory is
retained for only five minutes.
(c) Remove battery well cover and three batteries.
(d) Insert new batteries. The large terminal on each
battery goes in large hole, the small terminal in small hole,
(Figure 5-13).
(e) Replace well cover and tighten captive screws.
Figure 5-13.
Inserting New Batteries
(2)
When installing the RADIAC Set in the pouch:
(a) Orient pouch so that top cover is open and away from
you. Install probe in the left compartment by passing the straight
section of the coil cord nearest the probe connector through the
opening in the compartment flaps. Push probe to the bottom of pouch,
(Figure 5-14).
(b) Store coil cord at the bottom of the right-hand
compartment. Install RADIACmeter directly above coil cord.
5-17
IS0345
Previous Page
